It is completely different to use a stand-up forklift as opposed to a sit-down model. The way you move and lift loads as well as your movements are really different. If you do not have proper training for utilizing a stand-up model, you could potentially cause harm co-employees or to yourself. When utilizing a stand-up unit, you should follow the proper safety regulations. There are several basic operating standards which should be met when operating a stand-up model.
To begin on a stand-up unit lift truck, it is vital to get a good feel for the controls and the steering knob. Rather than a steering wheel, the steering is handled using the knob steering plate. Take note that this knob moves very fast, hence, you need to get used to moving it carefully so as to be certain not to over steer. The horn is located on the control handle, as is the control for backwards, forwards and the movement of the forks. The floor pedal allows the forklift power to move.
If you are set to start, turn the key to start the machinery. Be sure that your forks are not extended. If you are moving around the floor, the forks must be pointed slightly upwards. Never drive with extended forks. If you are moving forward, move the control handle forward and step on the pedal to make the lift move forward. If you are backing up, be certain to beep your horn to alert individuals around you. Look behind you before stepping on the pedal so as to make sure the way is clear and safe. Then, while stepping on the pedal, pull the control handle towards you. Stay focused and alert and make sure that you are always operating in a safe way.
When approaching a corner with the lift truck, turn the steering knob in the direction you are heading. Make sure to keep your foot on the accelerator and keep your hands on the control handle. When turning right, the steering knob will move in a clockwise direction while moving forward. If you are turning left, your steering knob would go in a counter-clockwise direction.
The stand-up units take some getting used to, particularly if you have only used sit down models. With some training and taking some time to figure out the machinery, you can handle loads efficiently and quickly in little time.